Hi I am a new member! I found the page while searching for "How to weld Stainless Steel" and it looks like a Cool site with a lot of interesting Stuff. I have a problem as indikated in titel. I'm lost in Thailand. Lost in the sence that I can not get (or trust) the workshops to do as I want them to. 2 reason, difficult to communicat & Asian mentality (No offence!) If I want it in 87.5 degree angle, then 88 degree want do! And this is frustrating. I do not know fiddle about welding but anything is better then the frustration of getting Zero progress. So if anyone can advice me on the subject I would be much obliged! Which system is easiest to start of with Ac/Ox - TIG - MIG?I have AC/OX full set 150$, TIG same & MIG 175-200$ to choose fromWhat I need to weld is SS Sheetmetal 2mm, Pipes OD25mm x 2mm and rods 5mm.Strength is not of a great concern for the moment in regard to this project.I kind of fancy Ac/Ox, but have heard alot about MIG & TIG.Which of these systems will be most inexpencive to use?Any help received with entushiasm so I can get out of the sinkhole I am in at the moment.Lost Viking